Warren Hall
Articles
Set a product type image
Before you begin
You are on the Product Types tab
You have the product type item selected for which you wish to set the image
You have the new image open in Paint
St...
Set Shape Properties
Background
Shapes are most obviously defined by an image overlaid with dimensions, saw cuts, and thread ends, but also have other properties which may be set.
Property
...
Set up device instructions
Background
Shapes are ultimately produced in the factory on machines. For machines such as off-coil machines, an operator typically enters a series of length-angle steps into the console and once...
Setup Device Instructions for Cut-length Calculations
Before you begin
Ensure you are logged into the Elda (Chrome) Products application. See our article Getting Started with Products for more on accessing the Products module.
St...
Troubleshooting: App non-responsive processing
Issue
Shortly after clicking Process Direcotry, Delivery Docket Scanner goes non-responsive
Causes
Problem with file
One cause is the app cannot process the file
This is one example o...
Change Log for MDI Scanner App
All notable changes to this project will be documented here.
In this article you will encounter the following change types:
Added for new features and functionality.
Changed for changes in existin...
Unlock an invoice
Before you begin
You have Invoice open
Steps to take
Select the invoice
Click Unlock Invoices
A message box appears to confirm you wish to proceed with unlocking th...
Configure a BitConnect device
Before you begin
It is highly recommended you have a DHCP reservation for the BitConnect device
Have on hand the serial communications settings required by the factory machine
Have an antenna conn...
Reset a BitConnect device
Overview
There are occasions when you might want to reset a BitConnect device back to factory defaults.
The BitConnect device doesn't seem connect to the specified Wi-Fi network
The
...
Configure to operate in bridge mode
Before you begin
After tapping Apply, the device will prompt to reboot. Rebooting is not necessary at every step and can simply be done as the final step.
Steps to take
Access th...
- Total activity 2216
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 26
- Subscriptions 2070