Modify a Count

Before you begin

Below are the steps to take to modify a count. These steps begin with the following assumption:

• You are viewing the count you wish to modify (See Find and View a Count)

Steps to take

Take the following steps to modify a count:

1. If required, change the count type of the count (See Change a Count’s Count Type)
2. Refer to the specific actions for the count type:
   • If the count type is Stock – Bar, see Modify a Stock – Bar Count
   • If the count type is Stock – Coil, see Modify a Stock – Coil Count
   • If the count type is Stock – HDW Coil, see Modify a Stock – HDW Coil Count
   • If the count type is Stock – HDW Cross Wire, see Modify a Stock – HDW Cross Wire Count 
   • If the count type is Stock – Mesh, see Modify a Stock – Mesh Count
   • If the count type is Stock – Sundries, see Modify a Stock – Sundries Count
   • If the count type is WIP – Bar, see Modify a WIP – Bar Count
   • If the count type is WIP – Coil, see Modify a WIP – Coil Count
   • If the count type is WIP – Offcut, see Modify a WIP – Offcut Count
   • If the count type is Other, see Modify an Other Count
     
     

After following the steps above, you may wish to:

• Create another count in the same section (See Create a Count from a Count)
• Send the stocktake (See Send a Stocktake)