Before you begin
Below are the steps to take to modify a WIP – Offcut count. These steps begin with the following assumptions:
- You are viewing the count you wish to modify (See Find and View a Count.)
- The count type of the count is WIP – Offcut (See Change a Count’s Count Type.)
Steps to take
Take the following steps to modify a WIP – Offcut count:
- If required, take the following steps to change the count method
- Tap on the edit button (pencil symbol inside a circle, located towards the top of the screen).
- Tap on the Count Method field and select the method by which you wish to count the offcuts.
The count is altered to reflect the new count method. For example, if counting by length and count, you cannot also enter a weight and so the weight field is disabled.
- Tap on the edit button (pencil symbol inside a circle, located towards the top of the screen).
- If required, tap in the Bar Type field and select the type of reinforcing bars being counted.
- If required (and permitted), tap in the Bar Length field then enter the length of the reinforcing bars being counted.
- If required (and permitted), tap in the Number of Bars in Bundle field then enter the number of reinforcing bars being counted.
- If required (and permitted), tap in the Weight of Bundle then enter the weight of the reinforcing bars being counted.
After following the steps above, you may wish to:
- Create another count in the same section (See Create a Count from a Count)
- Delete the count (See Delete a Count)
Comments (0 comments)